Technical parameters
- Frequency response (Hz)
- 10 ~ 100000 (±0.5dB@0dBu)
- THD (%)
- 0.05
- Impedance (Ω)
- 600 (Output)
470000 (Input) - Connectors
- 2 x 6.3mm TRS (Input)
2 x 6.3mm TRS (Thru)
2 x XLR (3-pin, Balanced output) - Width (mm)
- 127
- Height (mm)
- 51
- Depth (mm)
- 146
- Net weight (kg)
- 1.22
Product description
ART Dual Active Direct Box is a two-channel active device whose main task is to symmetrize the signal. The DI-Box has a very wide frequency response and low noise on the output signal.
The ART dADB front panel is equipped with two balanced XLR (three-pin) outputs with an impedance of 600 ohms. Each output has assigned buttons that enable or disable the following functionalities - phase inversion (PHASE), Bessel filter (low-pass) and ground disconnection (LIFT/GND). The middle button (BATTERY POWER) is used to switch on the battery power supply (9V). If the phantom power is detected by the DI-Box, the device will immediately start using it - in this case, turn off the battery power.
The middle LEDs indicate that the battery is low or DI-Box works in phantom power mode.
The back panel of Dual Active DI-Box has four 6.3-mm jack connectors - two of them are unbalanced/balanced inputs with an impedance of 470,000 ohms, and the other two are THRU connectors. An ATTENUATOR switcher is also available on each channel - it's responsible for signal attenuation (0/-20/-40dB).
Available in SQM Rental House ART dADB is known for its reliability and solidity.