- Mixer category
- Mixer type
- 2 (Mono, mic/line)
4 (Stereo, line)
- Frequency response (Hz)
- 10 ~ 150000 (-1dB)
10 ~ 200000 (-3dB)
- THD+n (%)
- 0.005 (A-weighted)
- Headroom (dB)
- 2 x 6.3mm TRS (Line balanced input)
2 x 6.3mm jack (Main unbalanced output)
2 x XLR (3-pin, Mic balanced input)
4 x 6.3mm jack (Phones TRS, FX, Control Room Out TS)
4 x RCA (2-Track, In/out)
8 x 6.3mm TRS (Stereo balanced input)
- Power supply
- 230V AC; 50Hz
- Width (mm)
- Height (mm)
- Depth (mm)
- Net weight (kg)
Behringer Xenyx 1002 is a 10-channel analog mixer, which is equipped with Xenyx microphone preamplifiers (XLR 3-pin female connectors) and a three-band equalizer.
The compact mixer also has plenty of 6.3 mm jack inputs - two mono balanced line inputs, eight stereo TRS connectors for line channels (3/4, 5/6, 7/8 and 9/10), as well as signal outputs for sending sums to foldbacks (TS). There is also a headphone connector, effects processor connector, and Main output. Additional stereo inputs and outputs (L/R, 2-Track) are also available on the left.
The lower panel contains a three-band equalizer with a constant value for high (12kHz), medium (2.5kHz) and low (80Hz) frequencies with the possibility of +/-15dB correction. Below them, there is a low-cut button that suppresses low sounds, FX knob that controls the signal output, panorama adjuster and an adjuster for the signal level of a particular channel.
The right side has i.a. signal volume fader for unbalanced outputs and a phantom power switch (48V) for condenser microphones.
The Behringer Xenyx 1002 mixer available at SQM Rental House is the perfect stage equipment.